AdventistSat GEOSATpro DVR1000ci Guia de Instalação descarregar pdf (Página 19)

www.adventistsat.com Toll Free 866-552-6882

Assemble the LNBF Clamp and attach the

LNBF clamp to the LNBF arm.

Example: Positive +20°

LNBF Rotation Angle: _______________

Install the GEOSATpro Mini Bullet

LNBF into the LNBF Clamp. Slide the

LNBF as far away from the reector as

possible so the tabs on the LNBF plastic

housing touch the LNBF clamp. Rotate

the LNBF in the circular clamp until the

centering line on the top of the LNBF

aligns with the LNBF Rotation specied

in the aiming coordinates.

Standing in front of the dish looking

towards the reector, rotate the LNBF counter clockwise (left) for

a positive (+) LNBF Rotation setting and Clockwise (right) for a

negative (-) LNBF Rotation setting. The Rotation Angle is marked on

the LNBF Clamp for Zero (0) and +/- 20

degree positions. Each mark on the clamp

measures 5°. Example: If the aiming

coordinates specify a LNBF Rotation of

+13, set the pointer to a position between

+10° and +15° counter clockwise (left).

Tighten both clamp screws (2).

If the aiming coordinates specify a number

greater than +/- 20 degrees, estimate the

additional number of degrees necessary

for setting the correct rotation angle. Example: If the Aiming

Coordinates specify a LNBF Rotation of -30, estimate and add an

additional 10° (two additional marks) and set the center pointer to

a -30° clockwise position.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 38 39

Sem comentários

AdventistSat GEOSATpro DVR1000ci Guia de Instalação Página 19